iCraft Deco Foil Adhesive Transfers - Let's Celebrate [19116]

Design + Foil = Spectacular! With Deco Foil Adhesive Transfers you can easily add adhesive sentiments, shapes, and patterns to all kinds of paper projects using either a die cutting machine or hot laminator.

Included in the package are 2 identical approximately 6" x 6" sheets, with each having a clear bottom liner and a printed one on top so you can see the design, pattern, or sentiment. Here are the steps to apply the Adhesive Transfer and then foil using your choice of Deco Foil Foil:

1. Use scissors to cut the desired design element from the sheet of Deco Foil Adhesive Transfers. Carefully peel off the clear bottom liner, position the transfer on your project, printed side up, and lightly press it with your finger to secure it in place (do not rub hard).
2. Place your project inside a folded Deco Foil Craft & Carrier Sheet or parchment paper.
3. If using heat: Run through hot laminator with the folded crease as the lead edge. If using pressure: Run through manual die-cutting machine with the same sandwich used for wafer thin dies.
4. Remove your project from the carrier sheet or parchment paper and slowly peel back the printed top liner to reveal the clear adhesive design. You must peel the top liner slowly!
5. Cut a piece of foil slightly larger than the design and place it, color side up, on top of the adhesive. Return your project to the folded carrier sheet or parchment paper and run it through your laminator or die-cutting machine a second time to transfer the foil.
TIP: If your cutting plates are very worn, place a thin piece of card stock or copy paper over the top of the carrier sheet to help prevent cut lines from transferring to the adhesive.